Cod. 429266
Rev. 03/0209
Service Removal
25
6. SERVICE REMOVAL
• Removing the washer from service requires a specialised company.
• Never release the washer unsecured.
• To release the washer and subsequent transportation, refer to the same specifications and
cautions indicated for Installation.
When removing the machine from service
:
• Disconnect the external switch and lock it mechanically. Remove the power wires.
• Close and mechanically interlock the manual water supply valves. Remove water supply hoses.
• Disassemble the drain outlet pipe and empty any residual water left in the washing machine.
• Assemble the shipping restraints.
• Disassemble the door of the washing machine (consult the Authorised Technical Service).
6.1. Dismantling
Most of the machine’s components are made with recyclable or recoverable materials.
The injected pieces bear information on the materials that were used to make them.
The main materials are:
• Steel plates.
• Stainless plate.
• Grey cast iron.
• Aluminium
• Glass
• Polypropylene (PP)
• Ethylene Propylene (EPDM)
• ABS.
• Copper.
• Electronic components
To Previous Page
Loading...
