Handling instructions
for GISMA connectors
HI – 2007 - 001
Document: replaces
MV 2000-020,
MV 2000-030 and
MV 2005 - 011
First issue: 15.07.2008
Rev.-Index: -Z-
From: 29.07.2020
Page 21 of 44
Attention
For hybrid connectors (eg fibre optic and coax combined) it is necessary to ensure that only
the region of the insulating elastomer must be greased. Fibre-optic and coaxial contacts
must be kept absolutely free from grease to prevent losses.
Left: Ungreased insulator Right: greased insulator
Picture: grease filling of plug
Lightly grease the locking threads of the receptacles, pressure hull penetrators and the
through bulkhead receptacles e.c. with GISMA-FETT LP 430 (strongly recommended at
stainless steel and titanium threads).
Dirty connectors to be purged with GISMA foam cleaner (SCHAUMREINIGER). Allow three
minutes to react. In case of strong dirt repeat the procedure. Then rinse with clean water.
Following rinse with the enclosed cleaning liquid (SPÜLLÖSUNG) to neutralize foam cleaner.
Check to see if the plugs locking sleeve runs smoothly.
To Next Page
Loading...
