Handling instructions
for GISMA connectors
HI – 2007 - 001
Document: replaces
MV 2000-020,
MV 2000-030 and
MV 2005 - 011
First issue: 15.07.2008
Rev.-Index: -Z-
From: 29.07.2020
Page 9 of 44
Left: Ungreased insulator, Right: greased insulator
Lightly grease the locking threads of the receptacles, pressure hull penetrators and the
through bulkhead receptacles e.g. with GISMA-FETT LP 430 (strongly recommended at
stainless steel and titanium threads).
Dirty connectors to be purged with GISMA foam cleaner (SCHAUMREINIGER). Allow three
minutes to react. In case of strong dirt repeat the procedure. Then rinse with clean water.
Following rinse with the enclosed cleaning liquid (SPÜLLÖSUNG) to neutralize foam cleaner.
Check to see if the plugs locking sleeve runs smoothly.
To Next Page
Loading...
