Operation
Formula - 20071
20
4.1.6 Tracking Adjustment
Located under the seat on each pump control link. This adjustment is covered in the
maintenance section.
4.1.7 PTO Engagement Switch:
Switch must be pulled out to the ROTATE
position to engage the blades. Switch is
pushed in to the STOP position to stop the
blades.
4.1.8 Choke Control
Choke is used to aid in starting a cold engine.
DO NOT run a warm engine with choke in the
ON position. Moving the choke lever upward
will put the choke in the ON position and
moving the choke lever downward will put the
choke in the OFF position.
4.1.9 Throttle Control
Throttle is used to control engine speed.
Moving throttle lever upward will increase
engine speed and moving throttle lever
downward will decrease engine speed.
4.1.10 Park Brake Lever
Located on left side of the machine. The brake
lever engages a parking brake on the drive
wheels. Pull the lever up and rearward to
engage the brake. Push the lever forward and
down to disengage the brake. The unit must
be tied down and brake engaged when
transporting.
To Next Page
Loading...