How to fix if hot and cold are reversed Glacier Bay Bathroom Fixtures?
If hot and cold are reversed in your Glacier Bay Bathroom Fixtures, it's likely the lines are reversed or the cartridge is upside down. To fix it, rotate the cartridge stem 180° so that the notch is facing down towards the drain.
What to do if there is no flow or a low water flow in Glacier bay 874X-0001 Bathroom Fixtures?
If you're experiencing no water flow or low water flow with your Glacier Bay Bathroom Fixtures, the most common cause is that one or both water supplies are not fully turned on. To resolve this, turn both water supply valves counterclockwise to the on position.
Why is my Glacier Bay Bathroom Fixtures leaking or dripping?
If your Glacier Bay Bathroom Fixtures are leaking or dripping from the spout when the handle is closed, it's probably due to the grommets not sealing properly. The solution is to replace the cartridge.
What to do if handle cannot be installed on Glacier bay 874X-0001?
If the handle cannot be installed or rubs against the escutcheon on your Glacier Bay Bathroom Fixtures, it's likely that the valve is installed too far back from the finished wall. To correct this, reinstall the valve (refer to Step 2 of the Installation section).
Why is the handle hard to turn on Glacier bay 874X-0001 Bathroom Fixtures?
If the handle on your Glacier Bay Bathroom Fixtures is hard to turn, the bonnet nut might be too tight. To resolve this, loosen the bonnet nut and reinstall it, being careful not to overtighten it.
What to do if water comes out of the tub spout and showerhead at the same time Glacier bay 874X-0001 Bathroom Fixtures?
If water comes out of both the tub spout and showerhead at the same time in your Glacier Bay Bathroom Fixtures, several factors could be at play. First, if the leak from the tub spout is less than 0.01 GPM when the water flow switches to the shower, this is normal. Otherwise, consider that the pipe used between the valve and the tub spout is not 1/2 in. IPS, or the COPPER pipe is incorrect, or the distance between the valve and the showerhead is less than 48 in., or there is a restriction between the valve and the tub spout, or the valve is installed upside down. To address these issues: Change the pipe to IPS or COPPER. Ensure the distance from the showerhead and valve is at least 48 in. Remove the tub spout and flush out debris and/or replace the undersized line or fittings. Remove the v...
Steps for preparing the installation site and shutting off water.
Procedure for installing the valve body and removing the plaster guard.
Instructions for connecting hot, cold, shower, and tub outlet pipes.
Steps to adjust the temperature limit stop and reinstall components.
Addresses issues like reversed connections, low flow, and leaks.
General| Mounting Location | Deck Mount |
|---|---|
| Number of Handles | 2 |
| Color/Finish Family | Chrome |
| Finish | Chrome |
| Spout Reach | 4.5 inches |
| Flow Rate | 1.2 GPM |
| Installation Hole Requirement | 3-hole |
| Material | Metal |
| ADA Compliant | Yes |
| Warranty | Limited Lifetime |
| Product Type | Faucet |
| Mounting Type | Deck Plate |
To Next Page