WWW.GLADIATORPADDLEBOARDS.COM INFO@GLADIATORPADDLEBOARDS.COM
GLADIATOR PADDLEBOARDS USER GUIDE
INFLATION
Unroll your board so
that it lays top-side
up.
Push the valve
button down and
give it a half twist....
this will pop it up
into the UP position.
Attach the pump
hose with a half
twist clockwise onto
the valve.
Begin pumping. For
best posture keep
a straight back and
bend your legs with
each pump stroke.
Remove the pump
hose with a half twist
anti-clockwise. Screw
on the valve cap.
Once you have taken the cap o the valve
with a half turn anti-clockwise you will
notice a spring loaded push-button. When
this is in the DOWN position air is able to
ow freely both in and out through the
valve. When it is in the UP position air
can only ow into the board. Change the
position of the button with either a push
and half twist or push and click.
THE VALVE
Over-Ination is not covered by
warranty so take the utmost care,
especially if using an air-compressor,
not to over inate the SUP. We
recommend that you inate your
SUP to 15-20psi (check valve for
details).
To Next Page
Loading...
Need help?
General