WWW.GLADIATORPADDLEBOARDS.COM INFO@GLADIATORPADDLEBOARDS.COM
GLADIATOR PADDLEBOARDS USER GUIDE
It is very easy to remove the valve on your
paddleboard to check its operation and replace
it if necessary.
VALVE REMOVAL
Use the valve removal tool that is provided
in your repair kit. Unscrew the cap of the
valve and then place the tool into the valve.
Turn anti-clockwise to unscrew the valve.
Once you’ve loosened it with the tool, you
can repace the cap and unscrew the valve
the rest of the way by hand.
Check that the rubber seal on your valve is
in the correct position and that the valve
opens and closes easily when you push the
button on the top side of the valve. If your
valve is broken please contact us to arrange
a replacement.
Replace the valve by turning clockwise by
hand at rst, then switching to the tool
to nish tightening it. Make sure that the
thread is properly aligned before tightening
and be careful not to over-tighten the valve.
To Next Page
Loading...
Need help?
General