4
Attach the shelf to the legs using two hex bolts per side
(four bolts total). Do not completely tighten the bolts.
NOTE: The shelf is reversible, and can be installed with the
edge facing up or down.
Screw in casters. The casters can be tightened up with an
open-end wrench, if needed.
3. Attach shelf to workstation legs 4. Install casters
Complete the Assembly
Workstation Care
Wash the workstation with a mild detergent and warm water. Rinse completely and dry thoroughly.
NOTE: Do not allow water to remain on the workstation for any length of time.
Registering Your Product
There are many benefits of registering your product. Find out more and register your product online at
www.gladiatorgarageworks.com. Consumers in Canada can call 1-800-807-6777.
WARNING
Excessive Weight Hazard
Use two or more people to move and assemble
workbench.
Failure to do so can result in back or other injury.
Tighten all bolts, and using two or more people, stand the
workstation upright and place it in its final location.
1. Stand up workstation
To Next Page
Loading...
Need help?
General
