nation. Phase separation is common in alcohol blend fuels
since alcohol absorbs water and separates from the fuel
causing a gasoline rich top layer, and an alcohol/water
layer on the bottom.
If only
fuel containing alcohol is available, or the presence
of alcohol is unknown, you must perform more frequent
inspections for leaks and abnormalities. Any sign of leak-
age or deterioration requires replacement before further
engine operation.
Preliminary Guidelines
1. Safely secure your boat to the dock.
2. Do not smoke, extinguish all open flames, STOP all
engines and other devices that could cause sparks,
including the bilge blower.Do not use electrical
switches or accessories, shut OFF all stoves that may
produce a spark or flame.
3. Close all hatches, windows, doors, and compartments
to prevent the accumulation of fuel vapors.
4. Ensure a fire extinguisher is readily available.
5. Remove portable fuel tanks from the boat when filling.
Wipe any spilled fuel from portable tanks before plac-
ing them in boat.
6. Do not store fuel in areas that are not adequately
ventilated.
7. Use only fuel lubricants recommended by the engine
manufacturer.
Fueling
NOTE:See Section 2 Systems & Components for your
boat’s fuel tank capacity.
1. Always fuel in an area supplying sufficient lighting con-
ditions. Gasoline spills are unnoticeable under poor
lighting or in darkness.
2. Remove the fuel fill plate.
3.6
DANGER:Gasoline vapors are highly explosive.
Follow all safety precautions before, during, and after
fueling.
WARNING:Use only marine fuel hose marked “USCG
Type A” if replacement is necessary. Inspect all fuel
distribution lines often to reduce the risk of fire hazard.
WARNING:Vapor from spilled fuel is heavier than air
and will flow to the lowest part of the boat. Ventilate
before starting.
W ARNING:Do Not use fuels that incorporate any
form of alcohol or alcohol derivatives. Alcohol destroys
marine fuel system hoses and components, that could
result in hazardous leaks, fire, and explosion.
To Next Page
Loading...