3
VI. Operation Instructions:
1. Before you switch on the power for the first time , make sure the unit
has water flowing from the water outlet.
2. Switch on the power, the power indicator will light, the unit is on
standby. Regulate the temperature control knob on the cover of the unit
to your desired water temperature. Hot water will flow out in a few
seconds. Turning the water outlet valve off will automatically stop the
power and heating.
3. Water temperature regulation:
a. Changing the water flow by adjusting the water inlet valve will adjust
the temperature of outlet water.
b. When incoming (ambient temp) water temperature is very low,
regulate the outlet water temperature by adjusting both water inlet
valve and control knob.
4.
. This heater is not intended to be operated by children, or mentally
impaired personnel, unless under adult supervision and guidance.
6. Children are not allowed to play with the water unit.
7. When using water heater, the temperature of the heating tank will be
higher than 60℃, it will inhibit growth of Legionella bacteria.
To regulate the water temperature only by water inlet valve, turn the
control knob clockwise to the max.
5
6-8mm out of the wall. Mount the unit and determine the position of the
hole for the expansion bolt to fixed the unit, then drill the hole and
fasten the bolt.
4. The cold water supply to this unit must be portable & be within the
guidelines of the local authority. Before switching on the power, make
sure that all plumbing connection are completed, and the unit has water
flowing through the unit.
5. The unit must be properly earthed into 15amp power circuit .
6. The unit is only to be installed indoors and in a dry location
7. This heater should not be located where ambient air temp drops below 5℃
8. when connecting hoses to cold and hot
water inlets of the water unit.
DO NOT USE TEFLON TAPE
To Next Page
Loading...