What to do if sliding touch fails on Gleamous GL5 Water Heater?
If the sliding touch function on your Gleamous Water Heater isn't working, it might be because you're sliding your finger too fast. Try slowing down the speed of your sliding touch.
Why is there no normal water output from my Gleamous GL5 Water Heater?
There are several reasons why your Gleamous Water Heater might not be outputting water normally. Here's what to check: * Make sure there is a water supply and that the water inlet valve is open. * Verify that the water inlet and outlet are connected correctly. * Ensure that the water pressure is normal (higher than 2L/min). * Inspect and clean the filter mesh in the water inlet, as it may be jammed. * Also, check and clean the shower head, as it could be jammed.
What to do if Gleamous Water Heater water temperature is too low?
If the water temperature from your Gleamous Water Heater is too low, ensure that the temperature is set to your desired level. Also, check the water flow rate and decrease it if it's too high.
What to do if Gleamous GL5 Water Heater water temperature is too high?
If the water temperature from your Gleamous Water Heater is too high, set the temperature to the desired setting.
Why is my Gleamous GL5 leaking from the water inlet or outlet?
If your Gleamous Water Heater is leaking from the water inlet or outlet, it's likely that the water pipe isn't connected properly or the rubber gasket is damaged. Try reconnecting the water pipe securely, or replace the gasket if needed.
How to fix water leakage from Gleamous GL5 inlet/outlet?
If you notice water leaking from the inlet or outlet of your Gleamous Water Heater, it's likely due to a poor connection of the water pipe or damage to the rubber gasket. Try reconnecting the water pipe securely, or replace the gasket if it's damaged.
Why is the water temp too low on my Gleamous GL5 Water Heater?
If the water temperature from your Gleamous Water Heater is too low, the temperature setting might be set too low. Adjust the temperature to your desired setting.
Why is the water temp too high on my Gleamous Water Heater?
If the water temperature from your Gleamous Water Heater is too high, the temperature setting may be set too high. Adjust the temperature to your desired setting.
What does malfunction code “E4” mean on my Gleamous Water Heater?
If your Gleamous Water Heater displays malfunction code “E4”, it indicates that the outlet water temperature is higher than 60 degrees. You should check the cause of this high temperature.
How to adjust the temperature if my Gleamous GL5 is too hot?
If the water temperature from your Gleamous Water Heater is too high, the temperature might be set too high. Try setting the temperature to your desired setting.
Provides critical safety points and warnings for the operation and installation of the unit.
Details user responsibilities regarding understanding, installation, and maintenance of the water heater.
Diagram and labels identifying the main components of the GL5 water heater.
Covers unpacking, component checks, and selecting a suitable location for installation.
Specifies electrical connection standards, wiring, earthing, and conductor sizing.
Illustrates the mounting procedure and required dimensions for fixing the water heater.
Details the wiring process and provides a schematic diagram for three-phase connections.
Details the interface and initial setup steps before using the water heater.
Step-by-step guide on how to use the water heater controls and adjust settings.
Provides crucial advice on showering, power off procedures, and long-term storage.
Specifies the maximum safe outlet water temperature during operation and showering.
Guide on cleaning the appliance, hand-shower, and filter mesh.
Lists common problems, their causes, and suggested solutions for the water heater.
Important reminders on earthing, immediate shutdown, frost prevention, and disposal.
General| Brand | Gleamous |
|---|---|
| Model | GL5 |
| Category | Water Heater |
| Language | English |
To Next Page
