Gleamous GL5 - Operation and Maintenance; Methods of Operation

7
C
D
E
F
G
H
I
B
A
GL5
A. Outlet water temp. & Malfunction code display B. Water flow status
C. Sliding touch area D. Setting temp. & Water Flow E. Regulating key +
F. ON/OFF G. Regulating key – H. Sliding status display I. Mode change key
1.Make sure the water heater has been properly installed.
Before operating the water heater, perform the following:
4.The minium water flow rate for operation is at least 2 L/Min.
3.Turn power on to the water heater only after the tank is completely filled
with water.
2.Completely fill the tank with water. (After piping has been properly connected
to the water heater, open the inlet valve and allow the tank to completely fill
with water to purge excess air. Then close the tap and check all connections
for leaks.
Methods of Operation