9
Maintenance instruction
C
lean the appliance with a damp cloth. It is ok to clean the cover
with
mild detergent, but
DO NOT use
turpentine, alcohol, petrol or any other corrosive solutions.
Clean the hand-shower regularly.
Clean
the
filter regularly: Disconnect the shower
head
from the hose. Remove the filter mesh washer and
flush it with water to remove any trapped sediments. Connect the
shower head
to the hose in its original
position.
Trouble Shooting
Trouble
Caused
Solution
Water leakage from
water inlet or outlet
The water pipe not be
connected well or rubber
gasket damaged
Reconnected the water pipe or change
the gasket
Power indicator is not
light
No power to water heater
Turn on power switch. Check for blown
fuses or tripped breaker
Power indicator is damaged Change the power indicator
Water output is not
normal or no water
output
No water supply or water inlet
valve shut off
Wait for water supply or open the inlet
valve
Wrong connection of water
inlet and outlet
Change to the correct connection.
Water pressure is lower than
2L/min
Use when the water pressure is nornal.
The filter mesh in the water
inlet is jammed
Clean the filter mesh
Shower head is jammed Clean the shower head
Water temp. is too high Temerature set too high Set temperature to desired setting
Water temp. is too low
Temerature set too low Set temperature to desired setting
Water flow rate is too high Decrease water flow
To Next Page
Loading...
