2
OUTLINE DRAWING OF GL5
POWER
INDICATOR
POWER
CORD
MODE
CHANGE KEY
DISPLAY SCREEN
TEMP. REGULATING
KEY+
TEMP.
REGULATING
KEY-
HOT WATER OUTLET PIPE
COLD WATER INLET PIPE
ON/OFF
Part Identifications
Installation Manual
Opening the Packing Materials
Attention: Do not remove any of the permanent instructions and labels.
Dismantle the exterior packing and place all components aside.
Inspect all parts prior to installation and start-up. Make sure there is no visible
damage.
Location Requirements
Select a suitable location near point of use.
Hot water pipe should be kept as short as possible to prevent excessive heat loss.
Carefully read all instructions before install.
After installation, dispose of packaging material in the proper manner.
To Next Page
Loading...