4
This section lists the items that are not included in your kit that you will need to fly and maintain your new Sabre RTF Micro-Electric
Helicopter. As you can see, there's not much to it!
RECOMMENDED ITEMS
The Sabre RTF Micro-Electric Helicopter includes a 7 cell Nickel Metal-Hydride flight battery and a 110V AC 2.5
hour wall charger to charge the flight battery. If you want to, you can purchase a second flight battery (P/N 165070) so you have
two. That way, you can take two fully-charged flight batteries with you to fly. That means twice as much flying fun!
We also sell a high-performance quick-charger that can charge the flight battery in about 30
minutes and is powered from your car's 12 volt DC battery or from a 110V AC wall outlet. This
enables you to charge the flight battery at the flying field, so you can fly as many times during
the day as you want.
For learning to fly, try our Training Gear (P/N 165251). The Training Gear attaches to
the landing skids and therby extends the landing gear, and adds protection and
stability to the helicopter during takeoff and landing.
PRO TIP
8 Pack Trinity "Sanyo"
AA Alkaline Batteries
(Part # 837801)
# 0 Phillips Head
Screwdriver
Lightweight
Machine Oil
Each transmitter comes with a sticker on the back showing which frequency in the 72Mhz band that the radio control system operates
on. The 72Mhz band is for aircraft and helicopter use only, so it's important to check the frequency if others are in the area before
turning on the radio control system. No two models can operate near each other if they are on the same frequency. If you turn on the
transmitter and someone else is flying on the same frequency, their model will lose control and crash.
If you go to fly at a dedicated R/C flying site, make sure to first become familiar with the frequency coordination that's in place.
BECOMING FAMILIAR WITH YOUR SABRE RTF MICRO-ELECTRIC HELICOPTER
# 1 Phillips Head
Screwdriver
10
9
13
12
11
1
2
8
6
3
4
7
5
1 - Antenna Mount
2 - Auxiliary Switch (2) - Not Used
3 - Auxiliary Button - Not Used
4 - Battery Condition LEDs
5 - Throttle/Yaw Control Stick
6 - Cyclic Control Stick
7 - On/Off Switch
8 - Trim Tab (4)
9 - Servo Reversing Switches
10 - DIN Connector for Simulator Adaptor
11 - Battery Cover
12 - Crystal Mount
13 - Charge Jack (for Optional NiCD Batteries)
Continued On Next Page
☛☛
☛☛
☛
Adjustable
Wrench
Wattage PF-12 AC/DC Peak Charger
Part # 130108
To Next Page
