What to do if my Global Water G3 Water Dispenser has no power?
If your Global Water Water Dispenser has no power, ensure it is properly plugged into an electrical socket and check for any improper connections.
What to do if the panel is not lit on my Global Water Water Dispenser?
If the panel on your Global Water Water Dispenser is not lit, check that the power cord is properly inserted into the socket. Also, ensure that the cold and hot buttons on the back of the cooler are switched to the “on” position.
Why is the cold water not cold enough in my Global Water G3 Water Dispenser?
If the cold water from your Global Water Water Dispenser isn't cold enough, consider these potential causes: * The dispenser may be too close to the wall. Ensure there is at least a five-inch space between the wall and the back of the dispenser. * The wire condenser on the backside may be dusty. Clean the wire condenser every three months. * The compressor may not have enough refrigerant. In this case, place the cooler in a well-ventilated area and adjust the thermostat.
What to do if my Global Water Water Dispenser won’t cool?
If your Global Water Water Dispenser won’t cool, check the cold temperature switch located at the back and ensure it is turned “on”.
Why is there no hot water at start up from my Global Water G3?
If there is no hot water at start up from your Global Water Water Dispenser, it's possible that the hot tank overheat protection sensor has tripped. To resolve this: 1. Unplug the cooler. 2. Allow the sensor to cool down for one hour. 3. Reach through the cooling grill with a pencil or narrow screwdriver to press the nude color reset button on the upper sensor located on the hot tank.
How to fix hot water that doesn’t flow out of the spigot of my Global Water G3 Water Dispenser?
If hot water doesn’t flow from the spigot of your Global Water Water Dispenser, air might be trapped in the line. Hold the hot water spigot down for 30 seconds to relieve any trapped air.
Procedure for installing the drain saddle and connecting the drain line to the sink pipe.
Steps to sanitize the water tank and filters using liquid chlorine bleach for hygiene.
Schedule for replacing sediment, carbon, and post-carbon filters and the step-by-step replacement process for 'F' models.
General| Product Type | Water Dispenser |
|---|---|
| Model | G3 |
| Brand | Global Water |
| Power Consumption (heating) | 500W |
| Weight | 15 kg |
| Cooling Capacity | 2L/H |
| Heating Capacity | 5L/H |
| Voltage | 220V |
| Certification | CE |
To Next Page
