To Next PageTo Next PageHow to fix weak or no pressure in Global MUD DADDY?
To address weak or no pressure in your Global Pressure Washer, first, make sure all connections are tightly secured. Next, verify that the pump cap is securely tightened onto the jug. Finally, double-check that the rubber 'O' ring under the cap is properly in place.
General| Brand | Global |
|---|---|
| Model | MUD DADDY |
| Category | Pressure Washer |
| Language | English |
Rinse the jug with water before the first use for optimal performance and cleanliness.
Securely attach the hose to the jug's underside connection point and tighten the nut firmly.
Attach the other end of the hose to the spray brush using its similar connection nib.
Fill with cold/warm water and apply 15-25 pumps to pressurize the tank without overdoing it.
Unlock the trigger by pressing and sliding downwards, then press and hold to release water.
Add more pumps or water if the water flow begins to slow down during use.
Ensure all connections are tight, the pump cap is secure, and the O-ring is in place.
Check for and remove any blockages within the pipe or outlet tube.
Do not store water inside the bottle and brush if the temperature is below 32°F (0°C).
Always release pressure by opening a cap when the Mud Daddy is not in use to ensure safety.
