3 - ASSEMBLY
1.
stage.
2. Place the handlebar in the housing at the top of the steering column and secure
the clamp with the two screws.
3.
1 2 3
4 - MODE OF OPERATION AND USE
ON/OFF FUNCTION
on; you are now in the “ON” mode.
- Your E10 will turn off automatically after 1 minute of inactivity; the battery lights
signal will also go off.
START-UP
To engage the motor, 2 actions are necessary.
Place your foot directly on the accelerator pressure sensor.
does not automatically cut the motor, see paragraph STOP regarding the
instructions for stopping the motor permanently.
CHECK SPEED
to slowdown)
- Once the electric motor is engaged, it will accelerate until reaching the cruising
engages again.
STOP
wait for the scooter to stop safely to get off the platform. The lights at the rear
an emergency. The battery will automatically turn itself off when the motor is not
engaged for more than 60 seconds.
5
ENGLISH
To Next Page
Loading...
