EasyManuals Logo

GLOBBER ONE K E-MOTION 4 Manual

GLOBBER ONE K E-MOTION 4
244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
WARNING! RISK OF INJURY BY PINCHING!
DO NOT INSERT YOUR FINGERS INTO THE
SHADED AREA INDICATED.

placing it in the housing at the top of the steering
column and secure the clamp with the 4 bolts.
SELF-STANDING MODE
This scooter can be put in self-standing mode by
simply moving the T-bar towards you, after you
have stepped on the Folding Lever. The wheel will
be slightly raised from the ground, for the scooter to
freely balance.
FOLD THE SCOOTER
1. Move the Folding Lever from a vertical to horizontal position. You can do this with your
foot or hand.
2. Step on the Folding Lever with strength until the folding mechanism is disengaged.
3. Lower down the t-bar until the folding mechanism clicks into place.
(a “click” sound will be heard)
FOLDING MECHANISM MAINTENANCE:
The folding mechanism might become loose after excessive use.
If such a case arises, please use the provided hex wrench to
slightly tighten the two bolts (Only slightly tighten the bolts to avoid
negatively impacting the folding mechanism).
MOUNTING FRONT LIGHT & BELL:
Take the LED light out from the box and charge it for 2 hours
with the USB cable provided in-pack. Unplug the cable when the
light is fully charged and install the LED light to the top part of
the handlebars; place it on the left-hand side with the light facing
forward. Fix it tightly with the pre-set elastic strap on the light.

loop opened and mount the bell on the right-hand side of the

4 - MODE OF OPERATION AND USE
ON/OFF FUNCTION
- This scooter has a Kick Start function.
- To start, push your scooter forward, the motor engages when speed reaches 5km/h. The
battery lights signal on the deck will turn on; you are now in the “ON” mode.
- Your E15 will turn off automatically after 1 minute of inactivity; the battery lights signal will
also go off.
START-UP
- Place a foot on the round acceleration sensor located at the top of the deck.
- You are in a position to start: push the scooter with your foot with more than 5 km/h to
engage the electric motor. Be aware that once the motor is turned ON, reducing your
speed below 5km/h does not automatically cut the motor, read the paragraph STOP for
instructions on how to switch off the motor.
5
ENGLISH

Table of Contents

Other manuals for GLOBBER ONE K E-MOTION 4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GLOBBER ONE K E-MOTION 4 and is the answer not in the manual?

GLOBBER ONE K E-MOTION 4 Specifications

General IconGeneral
BrandGLOBBER
ModelONE K E-MOTION 4
CategoryScooter
LanguageEnglish

Related product manuals