Glow-worm ASCOT 1.4S - Page 5

3.2
Preparing
the Applianbe
The
controls
lray should
be
removed
by
pulling
it
forward and
disengaging.
Refit
as required after
insullation, see
diagram
4.
Undo the two
casing securing
screws,
diagram
4,
which rerain
the front casing,
ease
the
case forward
at the bottom
and
push
upward until clear of
the
fixing bar
at the top of the
appliance, the
front
casing
can
now
be
removed.
Remove
the flue hood by releasing
the hook and
bols
from the
water
pipes
on
the
heating
body
and
undoing
the two screws at the back of
the
flue
hood.
Care
should
be
taken to
avoid
knocking
or
distorting
the top of the heating
body,
see
diagram 5.
Remove the
backing
strip
from the
self
adhesive
seal
provided
and fit it around the
spigot
on the
back o[
the heater
with
the
wide adhesive
edge
to
the
back of
the case,
see
diagram
6.
3.3
Fitting the
Appliance
Flue
Set
Note:
The sandard
flue set covers
wall thicknesses
from
100mm to
380mm
(4in
to
15in). For
wall
thicknesses up to
533mm
(2lin)
an optional
flue set
is
available to order.
At this
stage,
account must
be
taken
of
the
wall
thickness.
If less than 230mm
(9in)
the duct
and
liners will have
to be cut to
suit.
The
pars
afiected
are
the terminal assembly
"A",
diagram
6,
the out.let duct
"F"
and the
wall
liner sleeve
"G".
The smndard
flue
set can
be
cut to accommodate
walls
down to
i00mm
(4in).
Measure the
wall
thickness and subuact from 230mm
(9in)
to
give
the amounl. to
be
removed
from fre mating
ends of
componens
A,F
and G.
lr{ark out
and
carefully
cut the
required
parts, for
wall
thicknesses
of
230mm
(9in)
to 380mm
(l5in)
the sundard flue
set
requires no modification.
Fix the
three slotted straps
"D"
to the terminal
wall
liner
"A"
by
inserting
them over
the
lugs on the
terminal.
Bend
bottom
lug
flat then
bend
three
remaining lugs
so
that
straps are held firmly
in
posiLion.
WARNING: TAKE
EXTREME
CARE
TO
AVOID
LACERATING YOUR
HANDS
WFIEN
BENDING
TFIE LUGS.
Note:
For wall
thicknesses
greater
than 230mm
(9in)
the
slotted suaps
need
be
fitted
only to the
lugs
nearest
the
heater
end of the terminal
assembly. The lugs further into the terminal
asscmbly are for use only when
be
flue
pars havc
bcen
cut
to
suit a
wall
lcss
than
230mm
(9in)
thick.
Fit
the
wall
plate
"B"
over
the terminal assembly
ensuring that
the
plain
side
faces outward.
FLUE HOOD
sEcuRrNG
scREW(2)-
HOOK BOLT(2)
Diagram
i.l;{:
:i
1
r