Glow-worm ASCOT 1.4S - Page 6

Fit the terminal assembly
into
the
wall from
the
outside
ensuring
that
the
slotted
strap
on
the long
side is uppermost.
Mount the
appliance
on the wall
by
fitting
the top
slotted suap
to the top lug
on the appliance
case.
This is
achieved
by
pulling
the top
srrap
right and
tilting
the appliance
slightly
from
the
borrom,
permanently
secure
the
strap
to
the lug
by
bending
the lug
forward.
Fit
No10x50mm woodscrews
to
the
bottom
of the
appliance
and
tighten.
Fit the
two remaining
slotted
straps
over
the lugs
on the
appliance case
and
secure
permanently
and
cut
surplus
length
off all
the
srraps.
Tape
the wall
liners
toget}er
from
inside.
Slide the
stainless
steel ducr
"F"
inro
the madns
seclion
as far
as
possible.
Tape ducts
together.
Replace
the flue
hood
and
secure
using two
rear
fixing screws
and
hook
bolts over
body warer
pipes
CARE MUST BE
TAKEN
NOT TO
DAMAGE
TIIE
HEATING
BODY.
Note:
The flue
set
can be
insulled from
inside the
building as
follows:
a) Proceed
to 3.3
above
b)
If necessary cut the ducts, see
puagraph
2
of
3.3.
c) Attach the slotted
suaps
"D"
see
paragraph 4
of
3.3.
d)
Firmly atLach a length
of stout
suing or
rope to
the
hole
provided
in
the
bottom
centre
fin
on
the terminal.
e) Remove
the
wall liner.
,) Feed
terminal assembly
through the
wall
to
the ouside.
g)
Feed the
suing
through the
wall
plate
"B"
ensuring that tlre
plate
is he correct
way
round,
and
then
guide
the
plate
through
the
wall
and
over the
terminal.
h) Feed the string through the wall
liner and refit
the
]iner
to the
wall.
i) Locate terminal into hole
and
pull
assembly
back
into hole
and
retain with the
string.
j)
Pass
suing through
appliance and mount,
refer
to
above, and
then
remove
the string.
k)
Now continue
as
above.
3.4 Water Connections
The
water
service must
be
in
accordance
with
the
current
issue
o[ 856700.
The heater's water
connections are by
15mm
o.d
copper
tails. The
outlet
rail is fitted
in
manufacture but the
inlet
rail and
water
service
cock are supplied loose. These
should
be
fitted
as
shown
in
diagram 7,
give
due attention
to the
orienLation of
the
service cock.
The cold
water
connection
can
be either
from
the
mains or a cistem.
A TERMINAL
ASSEMBLY
B
OUTER
WALL
PLATE
C
OUTER
CASE
D
FIXING
STRAPS
E FLUE
HOOD
F
OUTLET
DUCT
G WALL LINER
SLEEVE
H
SELF-ADHESIVE
SEAL