Safety
Now, it’s time to be serious. Improperly operating the Glowforge Air Filter unit can cause fire and
health hazards. These can result in serious injury or even death.
Before you start
● Read this manual before using your Glowforge Air Filter, and ensure everyone else who
uses it reads this too.
● Always follow all instructions in this manual, in the Glowforge Manual and in the Glowforge
App.
● Use the Glowforge Air Filter only with a Glowforge Basic, Plus, or Pro.
● Children require the supervision and assistance of an adult at all times.
● This product may be subject to regulations and standards, particularly when installed in an
educational institution or place of work. Ensure that you comply with all applicable rules.
Electrical Safety
To reduce the risk of electric shock or fire:
● Do not try to service, repair, or modify the Glowforge Air Filter in a manner not described in
this manual.
● Do not open any sealed portion of the Glowforge Air Filter or try to access the wiring.
Damage caused by opening the case is not covered by the warranty.
● If the Glowforge Air Filter or its power cord is damaged, unplug the power cord and contact
support@glowforge.com immediately.
● In the event of any emergency or malfunction, unplug the power cord on the back of the
unit.
● Use only a properly grounded 120 VAC outlet that meets local building codes.
● The Glowforge Air Filter may draw up to 3 amps. Ensure that the circuit can support at least
a 350 watt load. Note: a standard 15A household outlet can support both a Glowforge
printer and a Glowforge Air Filter if nothing else is drawing power from the circuit.
Copyright Glowforge, Inc. 2020 3
To Next Page
Loading...