Close the front door and lower the lid on
your Glowforge.
Save Everything!
If you need to ship your Glowforge, for example
for warranty service, you’ll need all the original
parts: boxes, handle locks, foam, plastic
covering, and important orange and red bits.
Store them safely - replacement packing
materials are $249.
Set Up Exhaust
Connect Hose to Unit
Use the hose provided. Slide the ring clamp around the hose then squeeze the two ends
of the clamp together to fit the hose and clamp over the exhaust connection on the back
of your Glowforge printer. Let go, then check to be sure the clamp is settled over the white
ring around the exhaust and will not come off with a gentle tug.
Copyright Glowforge, Inc. 2020 33
To Next Page
Loading...