3
Mounting the X2
Helmet Mounting
The X2 comes mounted to the helmet mount, this can be attached to almost any
helmet using the supplied Velcro (or cable ties). Attach the light by looping the
velcro through the vents of the helmet. Tip: Many helmet vents slope toward the
front of the helmet. Mounting the helmet toward the front of the helmet helps
prevent the light slipping forward during use.
Bar Mounting
The bar mount is designed to fit flush with the stem. From this position the X2
can be adjusted to any position around the circumference of the bar.
Pre-stretch the o-ring prior to use then loop it over one side of the bar mount.
Place the bar mount flush with the stem then stretch the o-ring around the bar
and loop it over the opposite side of the mount.
Headstrap
The light is attached to the headstrap by threading the headstrap elastic through
the slits in the helmet mount. The elastic is then secured to the headstrap
backplate. Adjust the straps to your preference.
Battery
The battery can be attached to/placed in any location that suits the user, i.e. Top
tube, back pack shoulder strap, in back pack, in riding jersey etc. To ensure there is
enough cable to reach your desired battery location use the provided extension
lead. A protective adhesive foam strip is supplied.
To Next Page
Loading...