GlucoMen Areo User Manual (English)

To Next Page

How to use the sampler

GlucoJect Dual PLUS

Wash hands or

the alternative site

(AST). Unscrew the

sampler’s tip by tur-

ning it counterclock-

wise.

Insert a new

sterile lancet into

the lancet holder and

push it fully.

Sampling AST

Place the sampler on the

skin at selected plug area.

Press and hold for a few

seconds, then press the

shutter release button

to take a blood test.

CAUTION!

NEVER use sampler on more than one per-

son. Take a new lancet for each sampling and

do not leave a used lancet in the sampler.

Press the lancet ejec-

tor with your thumb

while pulling out the

sliding sleeve for dis-

posing of the used

lancet.

Pull out the sliding

sleeve to lock the sam-

pler. Press and hold the

sampler against your

ﬁ nger and press the

trigger.

Adjust the puncture

depth by rotating the

tip. 1-2 for soft or thin

skin, 3 for normal skin,

4-5 for thick or harde-

ned skin.

NOTE! This is a concise quick reference guide. Detailed information can be found in the manual supplied with the meter.

Medeon Science Park Per Albin Hanssons väg 41, hus D SE-205 12 Malmö

Tel 040

–

32 12 70 Fax 040

–

32 12 71 www.menarinidiagnostics.se

Blood glucose measurement with wireless transmission

46302 - 10/15 GlucoMen areo_Quick guide - EN

Quick Guide

Error codes and messages

ER 1

ER 2

Er 3

Er 4

Er 5

System error hardware. Remove and insert the batteries again and repeat the

test with a new test strip. If error code persists, please contact customer service.

Test strip is damaged or used, or have the blood sample applied before

”blood drop symbol” began to ﬂ ash on the screen. Repeat the test

with a new strip.

Test strip was given the small amount of blood. Stick again to repeat

the test with a new test strip and the right amount of blood.

Test strip was removed or dislodged during the countdown. Repeat

the test with a new test strip.

NFC was disconnected during transmission. Repeat the NFC-transfer.

If the problem persists, contact customer service.

Your test result is higher than 33,3 mmol/L!

Your test result is lower than 1,1 mmol/L!

CAUTION! If HI or LO appears, contact your health care provider before

changing your treatment. Shown HI or LO repeatedly even though your

blood sugar levels are high or low, contact customer service.

Customer Service: 040-32 12 70 info@menarinidiagnostics.se

English

How to use the sampler

GlucoJect Dual PLUS

Wash hands or

the alternative site

(AST). Unscrew the

sampler’s tip by tur-

ning it counterclock-

wise.

Insert a new

sterile lancet into

the lancet holder and

push it fully.

Sampling AST

Place the sampler on the

skin at selected plug area.

Press and hold for a few

seconds, then press the

shutter release button

to take a blood test.

CAUTION!

NEVER use sampler on more than one per-

son. Take a new lancet for each sampling and

do not leave a used lancet in the sampler.

Press the lancet ejec-

tor with your thumb

while pulling out the

sliding sleeve for dis-

posing of the used

lancet.

Pull out the sliding

sleeve to lock the sam-

pler. Press and hold the

sampler against your

ﬁ nger and press the

trigger.

Adjust the puncture

depth by rotating the

tip. 1-2 for soft or thin

skin, 3 for normal skin,

4-5 for thick or harde-

ned skin.

NOTE! This is a concise quick reference guide. Detailed information can be found in the manual supplied with the meter.

Medeon Science Park Per Albin Hanssons väg 41, hus D SE-205 12 Malmö

Tel 040

–

32 12 70 Fax 040

–

32 12 71 www.menarinidiagnostics.se

Blood glucose measurement with wireless transmission

46302 - 10/15 GlucoMen areo_Quick guide - EN

Quick Guide

Error codes and messages

ER 1

ER 2

Er 3

Er 4

Er 5

System error hardware. Remove and insert the batteries again and repeat the

test with a new test strip. If error code persists, please contact customer service.

Test strip is damaged or used, or have the blood sample applied before

”blood drop symbol” began to ﬂ ash on the screen. Repeat the test

with a new strip.

Test strip was given the small amount of blood. Stick again to repeat

the test with a new test strip and the right amount of blood.

Test strip was removed or dislodged during the countdown. Repeat

the test with a new test strip.

NFC was disconnected during transmission. Repeat the NFC-transfer.

If the problem persists, contact customer service.

Your test result is higher than 33,3 mmol/L!

Your test result is lower than 1,1 mmol/L!

CAUTION! If HI or LO appears, contact your health care provider before

changing your treatment. Shown HI or LO repeatedly even though your

blood sugar levels are high or low, contact customer service.

Customer Service: 040-32 12 70 info@menarinidiagnostics.se

English

How to use the sampler

GlucoJect Dual PLUS

Wash hands or

the alternative site

(AST). Unscrew the

sampler’s tip by tur-

ning it counterclock-

wise.

Insert a new

sterile lancet into

the lancet holder and

push it fully.

Sampling AST

Place the sampler on the

skin at selected plug area.

Press and hold for a few

seconds, then press the

shutter release button

to take a blood test.

CAUTION!

NEVER use sampler on more than one per-

son. Take a new lancet for each sampling and

do not leave a used lancet in the sampler.

Press the lancet ejec-

tor with your thumb

while pulling out the

sliding sleeve for dis-

posing of the used

lancet.

Pull out the sliding

sleeve to lock the sam-

pler. Press and hold the

sampler against your

ﬁ nger and press the

trigger.

Adjust the puncture

depth by rotating the

tip. 1-2 for soft or thin

skin, 3 for normal skin,

4-5 for thick or harde-

ned skin.

NOTE! This is a concise quick reference guide. Detailed information can be found in the manual supplied with the meter.

Medeon Science Park Per Albin Hanssons väg 41, hus D SE-205 12 Malmö

Tel 040

–

32 12 70 Fax 040

–

32 12 71 www.menarinidiagnostics.se

Blood glucose measurement with wireless transmission

46302 - 10/15 GlucoMen areo_Quick guide - EN

Quick Guide

Error codes and messages

ER 1

ER 2

Er 3

Er 4

Er 5

System error hardware. Remove and insert the batteries again and repeat the

test with a new test strip. If error code persists, please contact customer service.

Test strip is damaged or used, or have the blood sample applied before

”blood drop symbol” began to ﬂ ash on the screen. Repeat the test

with a new strip.

Test strip was given the small amount of blood. Stick again to repeat

the test with a new test strip and the right amount of blood.

Test strip was removed or dislodged during the countdown. Repeat

the test with a new test strip.

NFC was disconnected during transmission. Repeat the NFC-transfer.

If the problem persists, contact customer service.

Your test result is higher than 33,3 mmol/L!

Your test result is lower than 1,1 mmol/L!

CAUTION! If HI or LO appears, contact your health care provider before

changing your treatment. Shown HI or LO repeatedly even though your

blood sugar levels are high or low, contact customer service.

Customer Service: 040-32 12 70 info@menarinidiagnostics.se

English

Need help?

Do you have a question about the GlucoMen Areo and is the answer not in the manual?

GlucoMen Areo Specifications

General

Measurement Range	20-600 mg/dL
Measurement Time	5 seconds
Operating Conditions	10-40°C, 10-90% RH
Sample Volume	0.5 μL
Battery Type	CR2032
Storage Conditions	-20-50°C, 10-95% RH

Summary

GlucoJect Dual PLUS Sampler Usage

Sampler Preparation and Operation

Steps for preparing the sampler, inserting lancet, adjusting depth, and taking a blood sample.

Alternative Site Testing (AST)

Procedure for using the sampler on an alternative site for blood collection.

GlucoMen Area Error Codes and Messages

Error Code Explanations

Details on error codes ER1 to ER5 and their troubleshooting steps.

Result Range Messages

Explanations for 'HI' (high) and 'LO' (low) blood sugar results.

Measuring Blood Sugar and Data Management

Blood Sugar Measurement Procedure

Steps for washing hands, inserting test strip, applying blood, and reading results.

Selecting Measured Value Marks

How to mark blood glucose results with meal or activity indicators.

Managing Results in Memory

Accessing and scrolling through stored measurement results.

Viewing Average Results

Displaying average blood glucose levels over different time periods.

Device Setup and Connectivity

Setting Time and Date

Procedure for setting the meter's internal time and date.

Wireless NFC Data Transmission

Transferring test results wirelessly via NFC to a compatible device.

Replacing the Battery

Instructions for opening the battery cover and inserting new batteries.

Related product manuals