To Next Page

To Previous Page

MALFUNCTION

08/2012 17

Display

Malfunction/Message

Troubleshooting

Sensor for start button

responds even as the

stripper is switched on.

1. Disconnect the stripper from the power

supply and carefully clean the start button

with compressed air.

2. Disconnect the stripper from the power

supply, disassemble the start button and

blow out the metal tube with compressed

air.

The sensor for the front

limit position is not

activated after the

machine was started /

there is no contact.

1. Switch off CS 60. Wait until the display

goes out and restart the CS 60.

If the error is still remains:

2. a.) Switch off CS 60

b.) Remove receptacle tray (protective

cover)

c.) Remove the clamping jaw cartridge

d.) Check if something is gotten jammed

between blade cover and clamping jaw

cartridge

e.) Check if a screw is loose at the blade

cover.

If necessary remove the jammed part /

tighten the loose screw(s).

Questions and Answers:

Need help?

Do you have a question about the GLW CS 60 and is the answer not in the manual?

GLW CS 60 Specifications

General