To
open the driver’s side
rear door, pull on the latch
release handle in the inside
of the door.
To close the rear doors, close the driver’s side door first.
Check to make sure both doors are completely closed.
The rear doors have a check assembly to keep the doors
from opening beyond
90
degrees.
To fully open the rear doors,
push in on the clip and lift
the check assembly up
off
the mounting bracket.
Do
this on each door. Replace the check assemblies on
the mounting brackets before closing the doors.
See the Caution following “Swing-Out Windows” in
this section.
2-5
To Next Page
Loading...
