To return the seatback to the upright position, do the
following:
1. Lift the seatback up and push it back into place.
2. Reconnect the center safety belt latch plate to
the buckle.
3. Make sure the seatback is locked into place by
pushing and pulling on it.
4. Repeat Steps 1 and 3 for the other seatback.
When the seatback is not in use, it should be kept in
the upright, locked position.
Rear Seat Operation (Extended Cab)
If your vehicle has an
extended cab, there may
be a forward folding seat
in the rear area.
To fold the rear seat down, pull down on the bottom of the
seat until the seat is in place. To store the seat, push the
entire seat up until it is flush with the trim panel.
The rear seat storage compartments must be in the
rearward position before folding the seat down.
1-10
To Next Page
Loading...
