Rear Seats
Rear Seat Operation
Entering or Exiting the
Third Row Seats
Regular Models
If your vehicle has the 60/40 Split Bench seat in the
second row, you must flip and fold the second row seat
following the instructions later in this section. See 60/40
Split Bench Seat (Second Row) on page 1-10. To exit
the third row seat with no assistance, do the following:
1. Reach over the second
row seat and pull up on
the strap loop located
in the center of the seat
where the seatback and
the seat cushion meet.
Then pull the seat
cushion up and push
it forward.
2. Next, push the seatback forward until it is flat with
the floor.
{CAUTION:
If the seatback is not locked, it could move
forward in a sudden stop or crash. That could
cause injury to the person sitting there.
Always push and pull on the seatback to be
sure it is locked.
Return the seat to the normal seating position when
finished. Push and pull on the seatback to make sure it
is locked in place.
Extended Models
The passenger’s side of both the second row 60/40 split
bench seat and the second row bucket seat has an
easy entry/exit feature. This makes it easy to get in and
out of the third row seat.
1-8
To Next Page
Loading...
