Returning the 50/50 Split Bench Seat(s)
from a Tilted Position
To return the seat to the normal seating position,
do the following:
1. Open the liftgate to access the controls for the
50/50 seat.
2. Pull the lever labeled 3 toward you.
3. While still holding the lever 3 toward you, grasp the
top of the seat and pull it toward you slightly.
4. Let go of lever 3 and pull the seat completely down.
5. Push down on the seat firmly. Try pulling it up
to make sure it is locked in place.
6. Pull up on the release lever labeled 1, located
on the rear of the seatback. Then pull up on the
seatback until it locks into the upright position.
{CAUTION:
If the seatback is not locked, it could move
forward in a sudden stop or crash. That could
cause injury to the person sitting there.
Always push and pull on the seatback to be
sure it is locked.
7. Push and pull on the seatback to make sure it
is locked.
1-15
To Next Page
Loading...
