4. Press and hold one of the five preset screen
buttons, at the bottom of the screen, until you
hear a beep or see the station displayed
on the selected preset button.
5. Repeat the steps for each preset.
See “Storing Radio Station Presets” under
Navigation Audio System on page 58 for more
information.
Setting the Time
To set the time:
1. Press the
O (power) knob to turn the
system on.
2. Press the MENU key to enter the configure
menu options, then press the MENU key
repeatedly until the time is selected or select
the time screen button.
3. Press the Set screen button.
4. Press the Hours and Minutes − (minus)
and + (plus) signs to decrease or to increase
the time.
See “Setting the Time” under Configure Menu on
page 45 for more information.
Entering an Address and Point of
Interest, and Storing Preset
Destinations
Entering an Address
To enter a destination by entering the city name
first:
1. If the radio is already on with a map disc
inserted, skip to Step 5.
2. Press the
O (power) knob to turn the
system on.
3. Insert the DVD map disc. See “Installing the
Map DVD” under Maps on page 19 for more
information.
4. A caution may appear. Select the OK screen
button to proceed.
5. Press the DEST hard key.
6. Select the
2 Address Entry screen button.
7. Select the state/province screen button,
if needed, to change the current state or
province. Enter the name or enter the
two-letter abbreviation. A list will display
or select the List screen button and select
the state or province.
9
To Next Page
Loading...
