Sidemarker Lamps
1. Remove the screws and
pull out the parkinghum
signal lamp assembly.
2.
Reach through the opening and turn the sidemarker
bulb socket counterclockwise and remove
it.
3.
Pull the bulb straight out
of
the socket.
4.
Put a new bulb into the socket and push it in until it
is tight.
5.
Put the socket back into the sidemarker assembly
and turn it clockwise to tighten it.
6.
Replace
the
parkinghurn signal lamp assembly and
tighten the screws.
To Next Page
Loading...
