4
Remote Keyless Entry Transmitter
Unlock
Press to unlock the driver’s
door. Press again to unlock all
doors and the liftgate.
The Unlock setting can
be changed in the Vehicle
Settings menu.
Lock
Press to lock all doors and
the liftgate. The driver’s door
will not lock if open.
Liftgate
Press and hold to open/stop/
close the power liftgate
F
.
Vehicle Locator/
Panic Alarm
Press and release to locate your
vehicle. The turn signal lamps will
ash and the horn will sound.
Press and hold to activate the alarm. The
turn signal lamps will ash and the horn
will sound until the button is pressed
again or the ignition is turned on.
Remote Vehicle Start
F
Press and release the Lock button and
then press and hold the button until
the turn signal lamps ash to start the
engine from outside the vehicle. After
entering the vehicle, turn the ignition to
the On position.
– During a remote start, the engine
will run for 10 minutes.
– Repeat these steps for an addi-
tional 10 minutes. A remote start
can be extended once.
– Press and hold the button
until the parking lamps turn off
to cancel a remote start.
With the vehicle in Park, push down the lever on the left side of the steering column to
adjust the steering wheel. The steering wheel can then be moved up or down and in or
out. After adjustment, pull up the lever to lock the steering wheel in place.
See Instruments and Controls in your Owner Manual.
Tilt/Telescopic Steering Wheel
F
Optional equipment
Note: To change the remote lock, unlock, and
remote start settings, go to Remote Lock, Unlock,
Start in the Vehicle Settings menu.
See Keys, Doors and Windows in your Owner Manual.
To Next Page
Loading...
