D5096S - 5 A SIL 3 NO contact Relay Out Module for NE or F&G/ND Load with open/short circuit diagnostic G.M. International ISM0301-5
4
Function Diagram
SAFE AREA, ZONE 2 GROUP IIC T4,
NON HAZARDOUS LOCATIONS, CLASS I, DIVISION 2, GROUPS A, B, C, D T-Code T4
MODEL D5096S
1
2
+
Termination
board
connector
In
5 +
6 -
3
4
Load and
Line
Diagnostic
Supply 24 Vdc
Fault Out
(35 V, 100 mA)
Power and
Fault Bus
+
-
F
+ 7
- 8
+ 11
- 12
10
+ 9
NC Service Load
Not SIL
Load Power DC/AC
(SIL 3) Out
NE or F&G/ND Load
All relay contacts are shown
in de-energized position
To prevent relay contacts from damaging, connect an external protection (fuse or similar), chosen according to the relay breaking capacity diagram.
To Next Page
Loading...
General