GMP E 140.30 - User Manual

Questions and Answers

D
Derek HillAug 3, 2025
What to do if the ironing plate does not heat up on my GMP E 140.30?
- T
  Tony MillerAug 3, 2025
  If the ironing plate on your GMP Laundry Appliance isn't heating up after you've adjusted the thermostat, it could be due to several reasons: * The safety thermostat may have been activated. To resolve this, reset the safety thermostat using its push button. * The thermostat probe might be disconnected. If the display shows 'Er1' (right) or 'Er3' (left), check the probe connections. * The thermostat probe could be in a short circuit, indicated by 'Er2' (right) or 'Er4' (left) on the display. Make sure to use the entire ironing surface properly. * There might be a significant temperature difference (over 40°C) between the right and left probes. Ensure you are using the whole ironing surface correctly.
W
wleeAug 12, 2025
What to do if the roller doesn't turn and the ironing plate doesn't drop on my GMP E 140.30 Laundry Appliance?
- T
  tina65Aug 12, 2025
  If the roller isn't turning and the ironing plate isn't dropping on your GMP Laundry Appliance, here's what you should check: * **Inverter Fuse:** A blown inverter fuse (F4) could be the problem. Replace the fuse and investigate the cause of the failure. * **Inverter Protection:** The inverter protection might be activated. Check the error message displayed on the inverter. * **Emergency Devices:** Emergency devices might be activated, displaying 'Err'. Deactivate any active emergency devices and then press the pedal.
B
brandon54Aug 25, 2025
Why GMP E 140.30 does not work when switched on?
- R
  Rachel ShannonAug 25, 2025
  If your GMP Laundry Appliance doesn't work when switched on, consider the following possibilities: * **Mains Power Failure:** Verify that the supply terminals are live. * **Magnetothermal Switch Intervention:** Check for dispersion toward earth. * **Card Protection Fuse:** A blown card protection fuse (F1-F2) could be the cause. Replace the fuse and identify what caused it to blow.