Oil Fill: Use
Non Detergent
Pressure
Adjuster
Knob
Oil Sight Gauge
(On Back Plate)
Read complete manual for full details.
www.gncindustries.com
Quick Reference
Initial Set-Up
• Set engine switch to “ON”
• Set engine gas shut-off to “OPEN” position
• Set engine choke to “OPEN”
• Set engine throttle to “FULL” (Rabbit)
• Set pump regulator
red knob
to “START”
• Set pump regulator
black knob
to “PRESSURE RELEASE”
• Pull engine recoil cord to start engine
• Set engine choke to “CLOSE”
• Set regulator valve - To “SPRAY”
• Adjust regulator knob to desired PSI
• Start Spraying. See calibration in Owners Manual
• Check pump and engine oil levels
• Check engine gas level. Add fuel as needed
• Fill Tank—DO NOT RUN UNIT DRY
Operations
Secure Pulley Bolt
to Key Way with
Blue Lock-Tight
1” Suction
¾” Return
Pressure
Release
Output to
Reel
Gauge
Initial Set-Up
Video
Operation
Video
Aux. Output Port
To Previous Page
Loading...
