Page 2
• Warning:
1. Never point the spray gun at people or animals.
2. The pump will produce high temperatures when
operating.
3. Keep hands and clothing clear of the belts and
pulleys when operating the pump.
4. Always use fresh water free of foreign debris
when filling the spray tank.
• Before Use/Start Up:
1. Check every fastener, including all hose clamps,
to make sure that the sprayer and the engine are
installed firmly to the frame.
2. Align the pump and engine pulleys in
a straight line and tighten the belts
appropriately.
3. Check engine (see engine manual)
and pump oil (non-detergent). Fill as needed to
recommended levels. DO NOT OVER FILL!
4. Check engine fuel. Fill as needed, with engine
manufacture recommended fuel.
5. Attached the spray gun to the spray hose and
tighten all clamps.
6. Set the pump pressure regulator to “Pressure
Release” and make sure the pressure regulator
knob is set to “Start”.
7. Check the on/off switches of engine.
8. Start engine.
9. Set the pump pressure regulator to “Spraying”.
10. Adjust the pressure by turning the adjustable
pressure regulator valve clockwise.
To Next Page
Loading...
