Power management
1. Without external power supply (cable/car ignition off)
the GNS 2000 will shut down automatically after 15 minutes
without a Bluetooth connection to reduce battery consumption
2. The GNS 2000 can be turned on again easily using the
on/off switch or by powering the device with an external
charging cable.
Reset
For technical reasons the GNS 2000 is not equipped with
a RESET switch. If you should experience an unexpected
malfunction - e.g. no data is sent or the partner device does
not recognize the GNS 2000 - please simply plug in the
external charging cable to perform a full RESET. An existing
Bluetooth connection should be terminated first.
Approvals
The declaration of conformity is available from the manu-
facturer.
CE: The GNS 2000 satisfies the R&TTE directives (99/5/EC),
the EMC directives (2004/108/EC) and the low voltage
directive (2006/95/EC) as issued by the EU commission.
FCC: This device conforms to FCC Part 15 subpart B,
section 15.247 regulations.
R&TTE Bluetooth EMC: This device also complies with EN
62479:2010 ; EN 60950-1:2006+A1+A11+A12;
EN 301 489-1 V1.9.2; EN 301 489-17 V2.1.1; EN 300 440-
2 V1.4.1; EN 300 328 V1.7.1 and is listed under Bluetooth
Qualified Products.
Although the GNS 2000 conforms to the current strict
guidelines and norms it cannot be guaranteed that other
devices will not be affected by interference.
To Next Page
Loading...
