Go Power! DC Install Kit
Owner’s Manual
1. Warnings
Avoid all electrical hazards. Disconnect batteries and electrical system from 120/240
VAC, or any other power source of electrical power, before attempting to install your Go
Power! GP-DC Install Kit.
Observe proper polarity throughout the installation process.
Work safely. Do not wear jewelry when working with electrical or mechanical equipment.
Use protective eyewear, gloves and apron when working with batteries.
Follow the safety precautions of the battery manufacturer. Do not produce sparks
when working in locations where flammable gases or vapors exist. Shield skin and eyes
from battery acid. If skin, eyes or clothing comes in contact with acid rinse thoroughly
with water.
Avoid electrical shock. Make sure all sources (inverter, shore power, generator) are
disconnected.
2. Installation Overview
Congratulations on becoming the owner of a GP–DC Kit. Please read and understand all
instructions before installing your new product for the easiest and safest installation.
Before installing kit, review the installation design with this DC kit Installation Manual.
Contact your Authorized Go Power! Dealer if in doubt as to this kit's suitability or
compatibility with your system. Retain this guide for future reference.
To Next Page
Need help?
General
