Go Power GP-PWM-25 User Manual

Owner’s Manual | GP-PWM-25 Regulator
8
© 2009 Carmanah Technologies Corporation
Last revised July 2009
Setting the Battery Type / Charging Profile
Set the Battery Type / Charging Profile by holding down
the B Button for 10 seconds. When the display begins
blinking you may set the Battery Type by toggling
through the Charging Profile numbers 1, 2 or 3 by
pressing the B Button.
Confirm the Battery Type / Charging Profile selection by
pressing the A Button.
Depending on the battery voltage when the GP-PWM-25
Power Up occurs, the GP-PWM-25 may do a Boost
Charge or quickly go into Float Charge. The Charging
Profile selected will commence the following day after a
Power Up.
Auto Equalize: The GP-WWM-25 has an automatic equalize feature that will charge and
recondition your batteries once a month at a higher voltage to ensure that any excess sulfation is
removed. This feature is recommended for Flooded batteries only. Check with your battery
manufacturer.
NOTE: This feature is only available for Charging Profile 1.
Battery Type
FLOODED AGM GEL
Charging Profile # 1 2 3
Float Charge @ 25°C: 13.7 / 27.4V
Bulk/Absorption
Charge @ 25°C:
Applied for 30 min each
morning
14.4 / 28.8V 14.1 / 28.2V
Boost Charge
Applied for 2 hours if
the battery voltage
drops bellow 12.3 volts.
14.4 / 28.8V 14.1 / 28.2V
Equalization Charge
Applied for 2 hours
every 28 days and if
the battery voltage
drops bellow 12.1 volts.
14.8 / 29.6V N/A N/A
The Boost Charge will occur in addition to the Bulk Charge. The
Equalization Charge will occur in addition to the Boost Charge.
If a charging cycle is unable to complete in a single day, it will
continue the following day.
The terms FLOODED, AGM and GEL are generic battery
designations. Choose the charging profile that works best with your
battery manufacturer’s recommendations.

Go Power GP-PWM-25 Specifications

General

Brand	Go Power
Model	GP-PWM-25
Category	Battery Charger
Language	English