Need help?Do you have a question about the Go Power TS-30 and is the answer not in the manual?
General| Amperage | 30 Amps |
|---|---|
| Automatic Transfer Switch | Yes |
| Type | Automatic Transfer Switch |
| Poles | 2 |
| Frequency | 60 Hz |
| Mounting | Surface Mount |
| Material | Metal |
| Voltage | 120 V AC |
Ensure generator is off, power cord unplugged, and inverter shut off before proceeding.
Choose an accessible interior location out of direct weather, near power cord entry or generator output.
Select a knockout that facilitates installation and service for wiring entry.
Mount unit securely to a solid surface using provided screw holes.
Connect ground, neutral, and hot wires to designated terminals following wiring standards.
Connect power cord and generator leads to specific relay terminals for configurations A and B.
Connect inverter and other power supply to specific terminals for Configuration C.
Install in hybrid system between inverter and power supply for designated circuits (Configuration D).
Understand low voltage effects on appliances and transfer switches, including contactor chattering.
Identify general low voltage causes like RV park wiring issues and use a voltmeter for diagnosis.
Diagnose localized low voltage from incorrect extension cords or high load situations.
Inspect wiring connections for physical interference with relay operation.
Learn how to bypass the time delay for instantaneous switching with non-generator sources.
Troubleshoot failed time delay module using diagnostic LED and bypass switch.
To Next Page
