REV B 10/09
6 3/8 x 1 1/4" HEX BOLT 2 1055A UPPER MOUNTING BRACKET
4 3/8 x 1" HEX BOLT 1 1055D DRIVER SIDE LOWER BRKT
4 3/8 x 1" BUTTON BOLT 1 1055P PASSENGER SIDE LOWER BRKT
6 3/8" FLAT WASHER 4 1/2" HEX NUT
10 3/8" LOCK WASHER 2 5/16 X 3/4" HEX BOLT
10 3/8" HEX NUT 2 5/16" FLAT WASHER
4 1/2 X 1 1/2" HEX BOLT 2 5/16" LOCK WASHER
4 1/2" FLAT WASHER 2 5/16" HEX NUT
4 1/2" LOCK WASHER 1 P200 PLUG KIT
PART LIST
ASSEMBLY INSTRUCTIONS
!"
READ THE ASSEMBLY AND INSTALLATION INSTRUCTIONS COMPLETELY BEFORE YOU BEGIN.
STEP 1. BEGIN THE GRILLE ASSEMBLY BY LAYING THE COMPONENTS OUT ON A PROTECTIVE SURFACE.
STEP 2. INSTALL THE TUBE CONNECTORS FROM THE P200 PLUG KIT INTO THE TOP TUBE.
STEP 3. POSITION THE STEP TUBE, CENTER PLATE AND TOP TUBE BETWEEN THE GRILLE GUARD SIDE
PLATES.
STEP 4. ATTACH THE STEP TUBE TO THE SIDE PLATES USING THE 3/8” x 1” BUTTON BOLTS, THE CENTER
PLATE USING THE 3/8” X 1” HEX HEAD BOLTS, FLAT AND LOCK WASHERS, AND NUTS, AND TOP TUBE
USING THE P200 PLUG KIT HARDWARE.
STEP 5. ALIGN THE GRILLE ASSEMBLY AND TIGHTEN ALL NUTS AND BOLTS.
1 OF 2
To Next Page
Need help?
General
