EasyManua.ls Logo

Go Rhino XE Series User Manual

Go Rhino XE Series
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
1
REV.01
INSTALLATION INSTRUCTIONS
PRODUCT SAFETY & LEGAL DISCLAIMER
© 2016 Go Rhino Products. All rights reserved
www.gorhino.com 589 W. Apollo St., Brea, CA 92821 P: 888 427 4466
IMPORTANT READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO
MAY CAUSE PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY.
Review the product package and contents prior to beginning the installation. Take care when
opening the packaging and removing items. If a return is needed you will want to return the product in
its original packaging if possible.
This instruction guide is provided as a GENERAL installation guide, some vehicles vary dimensionally
and may require additional steps.
Test fit the product on the vehicle prior to any third party modifications and or finishing. The
manufacturer and/or distributors do not accept responsibility for third party charges, labor and or
third part replacement modifications. Some modifications may void the factory warranty.
Exercise due-diligence when installing this product. The manufacturer and distributors of this product
do not accept any responsibility for vehicle damage or personal injury resulting from the installation of
this product. Careless installation and operation can result in serious injury or equipment damage.
This product is for general off-road use. All liability for installation and use rests with the
owner/operator.
INSTALLER: Once installation is complete, please return this guide along with other documentation
included in this product back to the consumer for future reference. The manufacturer/distributors of
this product do not guarantee this particular version will be available at a later date.
REV 3 05/13/2016
PART NO.
730500T
PRODUCT DESCRIPTION:
XE SERIES 50” WINDSHIELD LIGHT FRAME
APPLICATION:
JEEP WRANGLER JL & GLADIATOR JT
Question and Answer IconNeed help?

Do you have a question about the Go Rhino XE Series and is the answer not in the manual?

Go Rhino XE Series Specifications

General IconGeneral
MaterialSteel
Mounting TypeBolt-On
Weight Capacity300 lbs
FinishBlack Powder Coat
CompatibilityTruck

Summary

Product Safety and Legal Disclaimer

Mandatory Pre-Installation Safety Warnings

Read all instructions before installing to prevent injury or damage. Review package contents before starting.

Injury Hazards and Installation Safety

Work Area and Personal Protective Equipment

Maintain a clean work area and wear protective gloves and eye protection during installation.

Parts Included in Installation

Tools and Time Estimation

Installation Steps Overview

Step 4: Attach Light Frame Uprights

Position and attach the light frame uprights to the vehicle using specified screws, washers, and spacers.

Step 7: Secure Retainer Plates

Align and install screws to secure the retainer plates to the light frame uprights.

Step 8: Adjust and Tighten LED Bar and Uprights

Adjust the LED light bar position, then tighten all securing screws.

Limited Warranty Information

Related product manuals