Go Rhino DOMINATOR SERIES User Manual

REV/B
QTY PARTS DESCRIPTION
12 3/8” X 2” HEX BOLTS
24 3/8” HEX NUTS
24 3/8” LOCK WASHERS
48 3/8” FLAT WASHERS
QTY
12
4
2
1
1
PARTS DESCRIPTION
3/8” X 1” HEX BOLTS
D02 FRONT AND REAR MOUNTING BRACKETS
D03 CENTER MOUNTING BRACKETS
D24097P PASSENGER SIDESTEP
D24097D DRIVER SIDESTEP
INSTALLATION INSTRUCTIONS
Read the instructions completely before you begin the installation.
If your vehicle is equipped with factory running boards, remove the boards, brackets and fasteners.
This installation uses (3) mounting brackets per side, and requires drilling (2) holes in the lower body
pinch mold for each bracket.
It is the installer’s responsibility to confirm all measurements and that there are no obstructions such as
brake, fuel or electrical lines before drilling.
Step 1. Beginning with the passenger side measure reward from the front fender bolt (refer to diagram for
dimensions) and scribe (6) vertical lines on the body pinch mold.
DOMINATOR SERIES SIDESTEPS
ASSEMBLY & INSTALLATION INSTRUCTIONS
PART NO. D24097 02-08 DODGE RAM QUAD CAB
Do not attempt to install this product on any vehicle other than the one it is designed for and listed above!

Go Rhino DOMINATOR SERIES Specifications

General

Brand	Go Rhino
Model	DOMINATOR SERIES
Category	Automobile Accessories
Language	English

Summary

Dominator Series Sidestep Installation

Parts List

List of components and hardware required for installation.

Installation Instructions

Procedure for mounting sidesteps to vehicle pinch mold.

Step 1: Passenger Side Measurement

Step 2: Scribing Lines

Measure and scribe lines on the body pinch mold for bracket placement.

Step 3: Drilling Holes

Center punch and drill holes for mounting brackets.

Step 4: Attach Mounting Brackets

Step 5: Position Sidestep

Align and loosely attach the sidestep to the mounting brackets.

Step 6: Tighten Hardware

Align sidestep and tighten all mounting hardware securely.

Step 7: Install Driver Side

Repeat installation steps for the driver side.