2. Safety
2.1. Intended Use
The battery system is for residential and works with/without a photovoltaic
system. It is a 51.2V LiFePO4 battery storage system, with the control module on
itself. It could be operated in on-grid and off-grid modes with compatible
inverters.
The battery system could be connected to the PC through USB cable for
maintenance and firmware updating.
The battery system must only be used as stationary equipment.
The battery system is suitable for indoor use only (or well protected place from
raining, snow).
The battery system must only be operated in connection with a compatible
inverter. The list of these inverters could be found at www.gobelpower.com.
The battery system is not suitable for supplying life-sustaining medical devices.
Please ensure that no personal injury would lead due to the power outage of
the battery system.
Alterations to the battery system, e.g., changes or modifications are not allowed
unless the written permission of Gobel Power is achieved. Unauthorized
alterations will void the guarantee and warranty claims. Gobel Power shall not
be held liable for any damage caused by such changes.
The type label should always be attached to the battery system.
2.2. IMPORTANT SAFETY INSTRUCTIONS
The battery system has been designed and tested in accordance with
international safety requirements. However, in order to prevent personal injury
and property damage and ensure long-term operation of the battery system,
please do read this section carefully and observe all safety information at all
times.
2.2.1. Battery Module Leakage
If the battery modules leak electrolytes, contact with the leaking liquid or gas
should be avoided. The electrolyte is corrosive, and the contact may cause skin
irritation and chemical burns. If one is exposed to the leaked substance, do
these actions:
Inhalation: Evacuate the contaminated area, and seek medical help
immediately.
To Next Page