To Next PageTo Next Page
Need help?Do you have a question about the Goblin 380 KYLE STACY EDITION and is the answer not in the manual?
Contact points for sales and support worldwide.
Contact points for sales and support in Europe.
Detailed technical specifications for the helicopter model.
Critical safety and handling warnings for the helicopter.
Rules for safe operation and flying environment.
Guidance and symbols for the assembly process.
List of external parts and tools needed for assembly.
Essential tools and chemicals for building the model.
Breakdown of parts included in the main box and individual bags.
Instructions for preparing carbon fiber parts, including de-burring.
Step-by-step assembly of the left side of the main frame.
Assembly of the main frame structure.
Instructions for attaching the landing gear to the frame.
Assembling the main shaft support components.
Detailed steps for assembling the main shaft.
Installation of the 120-tooth main pulley.
Assembly of the front tail pulley system.
Connecting the blade grips to the rotor head.
Assembling the central hub of the main rotor.
Steps for assembling the main blade grips.
Detailed instructions for assembling the swashplate.
Steps for assembling the main rotor head components.
Mounting and connecting the swashplate servos.
Initial setup procedures for the HPS head system.
Mounting and connecting the tail servo.
Guidance on selecting motor and pulley for optimal performance.
Recommended motor, ESC, and pulley combinations.
Correct positioning of motor wires and mounting the motor.
Adjusting the motor belt tension for optimal operation.
Preparing carbon frames for ESC wire routing.
Mounting the Electronic Speed Controller (ESC) in the helicopter.
Mounting the FBL unit and receiver.
Routing and securing FBL/RX wires using zip-ties.
Assembling the tail pitch slider mechanism.
Detailed steps for assembling the tail rotor hub.
Connecting the tail pitch slider links.
Assembling the tail side plate.
Installing the bell crank lever for the tail.
Assembling the main tail system components.
Assembling the locking element for the tail.
Attaching the tail boom.
Assembling the M8 carbon block for the tail.
Connecting ball links to the tail system linkage rods.
Installing the main tail boom onto the helicopter frame.
Adjusting the tail belt tension.
Fitting and securing the helicopter canopy.
Securing the battery to the tray and inserting it into the frame.
Information on applying and registering the serial number tag.
Pre-flight checks and setup procedures.
Advice for initial flights and adjustments.
Recommended checks for wear and lubrication.
Exploded view and part list for the carbon frame.
Exploded view and part list for the transmission.
Exploded view and part list for the main rotor head.
Exploded view and part list for the tail system.
Spare parts for uniballs, linkages, pulleys, shafts, and dampers.
Spare parts for spindles, grips, swashplates, frames, and landing gear.
Common screw and fastener kits.
Assortment of nuts, washers, shims, grommets, bearings, belts, tools, and adhesives.
Various sets of standard and specialized screws and nuts.
More bearings, rods, belts, linkages, tapes, and tools.
General
