11
Cleaning the filters
Before starting any cleaning, ensure the
stick vac is not plugged into the mains
supply and is switched off.
1. Remove the dust canister and filter
assembly and empty as shown in the
‘Removing and emptying the dust
canister’ section of this manual.
2. Remove the circular sponge filter
from the filter assembly by pinching
the material tab at the top of the filter
and pulling upwards. Tap the filter
over a household bin to remove any
debris then set aside.
3. Remove any excess dust from the
filter assembly using a soft brush or
a clean paint brush. The filter can
be broken down into three parts.
Hold the top section and twist the
lower section, following the arrow
and wording markings on the filter
assembly that say ‘UNLOCK’.
4. Rinse the dust canister, filter assembly
parts and circular sponge filter under
warm water until the water runs clear
and leave to dry for 24 hours.
5. Once all the parts are thoroughly dry,
reassemble the filter assembly, using
the markings for ‘LOCK’, and place
back into the dust canister. Don’t
forget to put the circular sponge filter
back in the top of the filter assembly.
6. Replace the dust canister to the main
body as shown in the ‘Removing and
emptying the dust canister’ section of
this manual.
1
To Next Page
Loading...
