14
Replacing The Drive Belt
Check the drive belt carefully for wear, cuts and stressed areas. If the
drive belt appears worn, you will need to replace
it. To remove the drive belt, read the instructions
and follow the drawings below:
The drive belt is not included as spare part, contact Customer Service
helpline on the back page if a replacement is needed.
1. Grasp the old drive belt and remove from
motor shaft. Discard old drive belt.
2. Loop new drive belt over motor shaft and
stretch other end over floor brush in the
space provided between the bristles.
3. Place ends of floor brush down into slots on
sides as shown. Turn floor brush by hand
several times in the direction of the motor
shaft. If properly installed, drive belt will align
itself on floor brush.
4. Replace brush cover and
six screws.
1
2
3
4
Replace Brush
Cover and
Six Screws
To Next Page
Loading...
