ENG
ENG - 18
SECTION 8: AVOIDING MINOR FAULTS
All repairing which must be done on the machine should be done by authorized service. When
a repairing is required for your machine or you are unable to eliminate the failure with the help of
the information given below:
Unplug the machine.
Close the water tap.
Apply to the nearest authorized service station.
FAULT POSSIBLE CAUSE METHODS OF ELIMINATION
Your machine does not start.
It is not plugged. Insert the plug into the socket.
Your fuse is defected. Change your fuse.
The electric power is off. Check the electric power.
Start/pause button has not been pressed. Press the start/pause button.
The program knob is in O (off) status. Bring the program knob on the desired status.
The door is not shut properly.
Shut the door properly.
You should hear the click.
Your machine does not receive water.
Water tap is closed. Open water tap.
The water inlet hose may be bent. Check the water inlet hose.
The water inlet hose is obstructed. Clean the filters of water inlet hose. (*)
The valve inlet filter is obstructed. Clean the valve inlet filters. (*)
The door is not shut properly.
Shut the door properly.
You should hear the click.
Your machine is not draining water.
The drain hose is obstructed or bent. Check the drain hose.
The pump filter is obstructed. Clean the pump filter. (*)
The clothes are not placed inside
the machine in a well-balanced manner.
Spread the clothes inside the machine in an
orderly and well-balanced manner.
Your machine is vibrating.
The feet of your machine are not adjusted. Adjust the feet. (**)
Transportation screws are not removed. Remove transportation screws. (**)
There is a small amount of clothes
in the device.
It does not prevent operation of the machine.
Excessive amount of clothes are filled
in the machine or the clothes are not placed
in a well-balanced manner.
Do not exceed the recommended quantity of
clothes and spread your clothes in the machine
in a well-balanced manner.
Your machine touches a ripid object.
Prevent your machine’s leaning on a tough
place .
Excessive foam is formed in the detergent
drawer.
Too much detergent has been used.
Press the start/pause button.In order to stop
the foam,dilute one table-spoon of softener
in half liter of water and pour it in the detergent
drawer.Press the start/pause button after 5-10
minutes.Arrange the amount of the detergent
properly in the next washing process.
Wrong detergent has been used.
Use only the detergents produced for full
automatic machines.
The washing result is bad.
Your laundry too dirty for the program you
have selected.
Select a suitable program. (see Table-1)
The amount of detergent used is not
sufficient.
Use more detergent according to the detergent.
Clothes exceeding the maximum capacity
has been filled in your machine.
Put the clothes in your machine in a manner not
to exceed its maximum capacity.
Your water may be hard.
Use the amount of detergent according
to the declaration of the detergent producer.
Distribution of the clothes in your machine is
not well-balanced.
Spread the clothes inside the machine in an
orderly and well-balanced manner.
(*) See the section concerning the maintenance and cleaning of your machine.
(**) See the section concerning installations your machine.
•
•
•
To Next Page
Loading...