ENG
ENG - 5
ELECTRICAL CONNECTION
Your washing machine works with 220-240V and 50Hz.
A special grounded plug has been attached to the network cable of your washing machine.
This plug must definitely be inserted to a grounded socket with 10 ampere. The fuse flow
value of the electricity line attached to this should also be 10 ampere. If you have no such
sockets and fuses in your house, let it be made by a qualified electrician.
Our company will not be responsible for any damages that may occur as a result of
usage without grounding.
Insert the machine’s plug to a grounded socket which you can easly reach.
WATER SUPPLY CONNECTION
Your machine has a single water (cold) inlet.
To prevent from the leakages on the connection joints, 1 seal is included in the hose
packing.(Fit this seal on the end of the water inlet hose at the tap side.)
Connect the end with bracket of the water inlet hose to the water inlet valve at the rear of the
machine and the other end to your tap. In situations where you are not assured, let a qualified
plumber make the connection works.
Water pressure of 0,1-1 MPa from your tap will enable your machine to work more
efficiently.(0,1 MPa pressure means water flow of more than 8 liters in 1 minute from
a fully opened tap)
After connections are completed, check for the non-leakage of the connection joints
by turning on your tap completely.
Be sure that water inlet hoses are not folded, broken or crushed.
Mount the water inlet hoses to a 3”/4, geared water tap.
•
•
•
•
•
•
•
•
•
•
•
To Next Page
Loading...